From approximately the earlier years of the 1770s separate parts of a vessel such as spouts or lids were stamped out using a drop-hammer. The piece of Sheffield plate would be placed upon a striking block which had a die sunk with a model of the required shape. Then the hammer, the face of which was raised with the same shape as the sunken die, was manipulated from above by a rope between two vertical rods and, as it struck the block, the Sheffield plate was stamped into shape. The parts would then be soldered to the vessel. The introduction of harder steels made possible more sharply-defined pieces and during the Regency period entire units were produced in this manner. Die-stamping was a very important technique, advances in it contributing greatly to mass-production methods in both silver and Sheffield plate. By the last decade of the eighteenth century larger, flat pieces such as trays were being produced in this manner, suitably ornamented as already described. (more…)

Monteiths, punch bowls and punch ladles

The monteith, which looks like a punch bowl with an ornate rim arid lifting handles, fir ^whist appeared some 20 years after the Restoration but became more general during the later years of the seventeenth century and earlier years of the eighteenth. Monteiths are comparatively rare pieces, and therefore fetch high prices. Their scalloped and notched rims were generally removable. The monteith was filld with cold water, then glasses were hung by their foot upon the notchese, and thus allowed to cool in the water. When the monteith was not being used in l filled it punch. (more…)

Inkstands

Inkstands (standishes) were much favoured in both sterling silver and, from about 1760, Sheffield plate. Silver examples include the treasury inkstand: a rectangular box which contained an inkpot, pounce box and wafer box — a small adhesive disk for sealing letters — with a single- or double-hinged lid and perhaps a drawer below for quills. Another type, made in both silver and Sheffield plate, consisted of a rectangular tray, standing upon four small feet, which had three sockets. In the case of the silver version, the inkpot and pounce box would fit into the outer two sockets, while the middle one would contain a small hand bell, or taperstick for sealing. (more…)