From approximately the earlier years of the 1770s separate parts of a vessel such as spouts or lids were stamped out using a drop-hammer. The piece of Sheffield plate would be placed upon a striking block which had a die sunk with a model of the required shape. Then the hammer, the face of which was raised with the same shape as the sunken die, was manipulated from above by a rope between two vertical rods and, as it struck the block, the Sheffield plate was stamped into shape. The parts would then be soldered to the vessel. The introduction of harder steels made possible more sharply-defined pieces and during the Regency period entire units were produced in this manner. Die-stamping was a very important technique, advances in it contributing greatly to mass-production methods in both silver and Sheffield plate. By the last decade of the eighteenth century larger, flat pieces such as trays were being produced in this manner, suitably ornamented as already described. (more…)

A few years after the turn of the eighteenth century the spoon eventually developed into the utensil which we use today. By 1720 its stem had become gracefully curved and terminated in a flat, rounded end which turned forward or upward and upon which it was rested on the table, so that the back of the bowl was uppermost in the French way. This Hanoverian rat-tail spoon continued in fashion for a few more years, the rat-tail gradually disappearing to be replaced by small droplets, either one or two, at the back of the bowl, or the increasingly fashionable scallop-shell, typical of the rococo period. The stem evolved into a flatter form, terminating by the 1760s in a curve which turned in the opposite direction to its predecessor, ie backward instead of forward, so that the spoon could be placed on the table with the interior of its bowl showing,as is still the custom in England and elsewhere today. This is termed the `Old English’ pattern and has been the basic form for spoons ever since. (more…)

For many years tea was commonly drunk clear in the Chinese fashion and because of this and other reasons it is difficult to find a jug made earlier than the first few years of the eighteenth century. Early examples are in the pyriform shape, with a scrolled handle, sometimes positioned at a right-angle to the lip or spout. Diminutive cream jugs, standing no more than three inches high, were generally left undecorated, though others might have two rows of moulding at their waist. Both were made of a thick gauge metal and were weighty, despite their small size. In time the jug became more general, hammered up from the flat, with the cast spout and handle now opposite each other, standing upon a spreading moulded foot, and still with attractive scroll handles. (more…)